MANUAL | QUICK START GUIDE

TR40S Racing Simulator

In this Guide

A - SYMBOL LEGEND
B - PART LIST
1. B1 - COMPONENTS
1. B2 - ACCESSORIES
1. B3 - INCLUDED TOOLS
C - ASSEMBLY NOTES
D - ASSEMBLY INSTRUCTIONS
E - WARRANTY
F - LEGAL

A - SYMBOL LEGEND

IMPORTANT: Since there are different versions of each product based on your region, please make sure you are using the correct set of instructions. The part number on the following page should match the numbers on your product packaging.

IMPORTANT: Due to the nature of cut aluminum profiles, some metal shavings may remain despite our thorough QA cleaning process. We recommend opening boxes and packaging on a hard surface.

NOTE: Some screws and washers may be pre-installed. These are included in the parts list and will need to be loosened and reattached according to the instructions. Already pre-installed components are color-coded gray, while others are color-coded red, for example:

Color-coded red - supplied in the package separately

Color-coded gray - preinstalled

	Recommended: Two people for the task
	Tighten the hardware
	Keep the hardware loose for adjustments
	Make the necessary adjustments
	Break the tab off the corner bracket
	Safety glasses required
	Attention/Priority needed
	Reserve for the next step
	Mirrored components (same on both sides)

B - PART LIST

B1 - COMPONENTS

Aluminum profile

Rubber foot

Corner bracket, 40x40

Corner bracket, 40x80

End cup, 40x40

End cup, 40x80

Corner bracket

Corner bracket cup

Wheel mount

Pedal plate connector

Pedal plate

Front logo plate

Shifter side plate

Red profile strip

Wheel mount 1

Wheel mount 2

Short pedal

Pedal (optional)

B2 - ACCESSORIES

M8x16 flat hex screw

M8x20 flat hex screw

M8x30 flat hex screw

M8x16 cap hex screw

M8x20 cap hex screw

M8 flange nut

Cable management clip

M8 T-nut

M8x16 washer (flat)

M8x20 washer (flat)

M8 lock washer

B3 - INCLUDED TOOLS

5 mm ball end hex key

8 mm ball end hex key

C - ASSEMBLY NOTES

1 - Top side

2 - Outside

3 - Back side

4 - Front side

INSTALLATION ORDER FOR SCREWS WASHERS

1 - Screw
2 - Lock washer (if applicable)
3 - Washer

HOW TO MEASURE SCREWS

1 - Flat Screw
2 - Hex screw
3 - Button screw

BC-40 & CB-40

These brackets come with guide tabs on the rear. They help align the brackets to the profile when fitted in the same orientation as the profile. When used in the alternate orientation, these tabs are designed to snap off for a flush mount against the profile.

NS-M8 & NS-M6

Slide T-nuts into the ends of the profiles. Some must be added early, so follow the steps in this manual carefully.

If you miss one, tilt it from the outer edge. Use the Allen key to push it into place, ensuring the hole lines up.

OHK-M8-20

The handle screws are ratcheted to allow for tightening and loosening when space for rotationis is limited. Simply pull the handle out and turn handle into position and push it back in to engage thread.