Gran Turismo® DD Pro Wheel Base

To get started with using the GT DD PRO, decide on whether you will hard-mount the wheel base and pedals or use the CSL DD Table Clamp, connect your steering wheel via the Quick Release system, then connect the GT DD PRO to your PlayStation®5 console or PlayStation®4 console using the included USB cable. It is important to follow the chapter sequence of this manual for an effective assembly and setup procedure.

ATTENTION: See chapter “Connections” for which type of peripheral devices must be connected to which port at the rear of the GT DD PRO. All devices have to be connected to the GT DD PRO before powering ON to allow proper detection and operation. Only use the included USB cable from your GT DD PRO package contents to avoid damages! Ensure there is enough space around the wheel base to allow for air to circulate. Passive air circulation is sufficient.

Hard-mounting from the bottom (left) or side (right) of the wheel base is possible with the use of parts E (T-nuts).

Hard-mounting from the bottom (left) or side (right) of the wheel base is possible with the use of parts E (T-nuts).

ATTENTION: Mounting holes at the front of the wheel base are NOT for hard-mounting! Only for peripheral mounting such as static shifter paddles or a dash display. Thread length: 10 mm

NOTE: Bolts not included. Use only good quality bolts when hard-mounting. Bolt specifications: M6x(10+X) mm

Compatible Hardware

Compatibility with Fanatec Steering Rims/Hubs which are not official licensed PlayStation products, have not been tested and are not endorsed by Sony Interactive Entertainment.

To turn on the wheel base, connect the system to electrical power and press the power button on the right side of the wheel base for about one second. The wheel base will then immediately perform a start-up calibration.

To turn off the wheel base, press and hold the power button for 3 seconds.

To cycle through modes, short press the power button whilst the wheel base is on. The LED colour illuminating the power button will indicate the current mode.

BLUE PlayStation® - For use on PS5^TM consoles and PS4^TM consoles.

PURPLE PS4^TM Compatibility - Detected as a CSL Elite Wheel Base + PS4^TM. For use on PS5^TM consoles and PS4^TM consoles when the GT DD PRO is not detected or supported by the game.

RED PC - For use on PC and updating firmware.

YELLOW PC Compatibility - Detected as a ClubSport Wheel Base V2.5. For use on PC when the GT DD PRO is not detected or supported by the game.

Install the PC driver, then connect your wheel base to your Windows PC via USB. Ensure that your wheel base is in PC mode (see chapter I “Modes” for instructions). Open the PC driver, select ‘Firmware Update’, then select ‘Open Firmware Manager’ which will guide you through the update process.

Video Guide: https://www.youtube.com/watch?v=JmjQ2EEM03o