How to calibrate the wheel center of the Porsche GT3 V2 Wheel Comment calibrer le centre du volant Porsche GT3 V2? Kalibrierung der Nullstellung bei Porsche GT3 V2 Wheels

When the center position of your Porsche GT3 V2 Wheel does not match to the ingame wheel, if the "0 position" in the driver is not correct and/or after a firmware flash the wheel center has to be set. You do find the instructions also in the full downloadable manual:

1. Power wheel on
2. Turn the wheel to its center position
3. Press and hold the L3 and R3 buttons on your on your wheel rim
4. Additionally press the "Base Button"to set the wheel center. It will be stored in the firmware now.

 

Please keep in mind that the wheel position does not necessarily have to match the ingame wheel apart from the 0 position. This depends on the wheel angle ("SEN") which could be set in the wheel, in the driver or even within a game.

[tags: centering, nullstellung, calibrate, calibration]

Si la position centrée de votre volant Porsche GT3 V2 ne correspond pas celle du volant dans le jeu ou si le centrage du volant doit être réinitialisé après la mise à jour du firmware, veuillez suivre les instructions suivantes. Vous les trouverez également dans le manuel que vous pouvez télécharger. 

  1. Allumez le volant
  2. Centrez le volant manuellement
  3. Appuyez et maintenez enfoncés les boutons L3 et R3 sur votre volant
  4. Appuyez également sur le "Base Button" pour enregistrer le centrage du volant. Le paramètre sera sauvegardé dans le firmware

Veuillez noter que la position du volant dans le jeu et celle de votre volant ne sont pas obligatoirement identiques sauf en position 0. Cela dépend de l'angle de rotation du volant ("SEN") qui peut être réglé à partir du volant, du pilote ou même dans le jeu.

[tags: centering, nullstellung, calibrate, calibration]

 
 

Wenn die Nullstellung/Zentrierung ihrers Porsche GT3 V2 Wheels nicht mit jener im Treiber bzw. in einem Spiel übereinstimmt oder nach einem Firmware Update, muss thas "wheel center" neu gesetzt werden. Dies funktioniert wie im herunterladbaren Handbuch beschrieben :

 

1. Schalten Sie das Lenkrad ein
2. Drehen Sie das Lenkrad in die Nullstellung
3. Drücken und halten Sie die L3 und die R3 Taste
4. Drücken Sie nun zusätzlich den "Base Button". Beim Loslassen der Tastenkombination wird die Einstellung wird nun in der Firmware gespeichert.