MANUAL | QUICK START GUIDE

ClubSport Pedals V3 Damper Kit

PACKAGE CONTENT

CSP V3 DK Content 1

1x (A) Damper

1x (B) Damper Nut (pre-assembled)

1x (C) Pedal Arm Link (pre-assembled)

1x (D) Mounting Bracket

1x (E) Rumble motor bracket

2x (F) Screw S1DK (M6 x 10 mm)

4x (G) Screw S2DK (M6 x 12 mm)

2x (J) Screw S3DK (M4 x 6 mm)

4x (I) Washer W1DK

2x (K) Bushing W2DK

1x (L) Allen Key

ASSEMBLY

IMPORTANT: Please follow these steps carefully to avoid damages due to assembly mistakes!

CSP V3 DK Assembly 1

1: Disassemble the rumble motor, pull out the motor from the old bracket (1) and put motor into the new bracket (2).

CSP V3 DK Assembly 2

2: Attach the rumble motor upside down with the new rumble motor bracket.

CSP V3 DK Assembly 3

3: Attach mounting bracket onto pedal box.

(1 = Brake / 2 = Throttle)

CSP V3 DK Assembly 4

4: Hang in damper to pedal arm (Throttle: Lower holes at pedal arm).

(1 = Brake / 2 = Throttle)

CSP V3 DK Assembly 5

5: Fix damper nut in mounting bracket.

CSP V3 DK Assembly 6

6: Adjust and lock damper position: Turn the damper backwards until pedal moves a bit (a), then turn damper 180° towards the pedals again (b). Tighten the two screws by hand so that the damper cannot be turned anymore (c).

CSP V3 DK Assembly 7

7: Adjust damper effect:

- ‘0’ is almost no damper effect (weak)

- ‘8’ is highest damper effect (strong)

- spot on outer edge shows set position

CSP V3 DK Assembly 8

8: Fix adjusted damper effect.

(1 = close / 2 = open)

IMPORTANT: Before using the damper we recommend to check the pedal calibration!