FAQ: How to calibrate the H-Shifter (7GS and CSS) on CSR (Elite) Wheels

Before first use the H-gated shifter (7GS or CSS) must be calibrated to work properly. The calibration has to be done only once and will be saved in the firmware but it will be deleted after a firmware update. Please do it again after the wheel is updated/flashed.

1. Connect the shifter to the shifter port of your wheel
2. Power the wheel on
3. Set the wheel into PC mode (press "Back" Button)
    USB cable must be connected to engage the PC mode. For calibration you can connect the USB cable also to the Xbox 360 but the cable will NOT be needed later on for playing.
4. Press "Tuning Button" + "Start Button" simulanously
    Display will show G_n
5. Move 7GS (shifter) into neutral position and press "Start Button"
    Display will show G_r
6. Move 7GS into reverse gear position (push stick to the very left position and up) and press "Start Button"
    Display will show G_1
7. Move 7GS into first gear position and press "Start Button"
    Display will show G_2
8. Move 7GS into second gear position and press "Start Button"
    Display will show G_3
9. Move 7GS into third gear position and press "Start Button"
    Display will show G_4
10. Move 7GS into fourth gear position and press "Start Button"
    Display will show G_5
11. Move 7GS into fith gear position and press "Start Button"
    Display will show G_6
12. Move 7GS into sixth gear position and press "Start Button"
    Display will turn off again -> Calibration done!

You can also see the process in our Video Manual. The process works identically on CSR and CSR Elite Wheels.